Guide: now tractors are very common in rural areas. People not only use them for agricultural operations, but also use them for travel. However, in the process of tractor use, the tractor braking should be applied reasonably and maintained effectively, so as to keep it in a good technical state and braking effect, which is beneficial to safe driving, saving oil, tire wear and prolonging brake

Nowadays, tractors are very common in rural areas. People not only use them for agricultural operations, but also use them for travel. However, in the process of tractor use, the tractor braking should be reasonably applied and effectively maintained to keep it in good technical state and braking effect, which has a good effect on safe driving, saving oil, tire wear and prolonging the service life of braking parts, How to operate? Let's get to know. Correct use and maintenance of tractor brake system

 

1. Do not put your foot on the brake pedal for a long time during driving. During tractor transportation, the left and right brake pedals must be connected with interlocking plates to prevent deviation during braking. No matter in farmland operation or transportation operation, you can't put your foot on the pedal for a long time.

 

2. Regularly check and adjust the pedal of the mechanical braking system according to the requirements of the operation manual of each vehicle. The stroke of the left and right brake pedals of the tractor shall be adjusted uniformly, otherwise it is easy to cause partial braking and endanger safety. Tractor maintenance method

 

3. For the shoe brake, the clearance between the brake drum and the friction plate shall be checked regularly. Generally, the field test shall be carried out after adjustment to ensure no mistake. For the hydraulic braking system, the oil level height of the oil storage tank shall be checked regularly. When the oil is insufficient, the braking fluid of the same type shall be filled in time, the air in the braking system shall be discharged in time, and the damage and oil leakage in the whole system shall be checked. If any, it shall be eliminated in time.

 

4. Regularly check, test and adjust the braking efficiency of the braking system, and regularly inject oil and lubrication to each oil filling point. 5. When the friction surface of the braking system slips or the automatic separation is not clear due to the entry of oil and water, check and replace the relevant oil seal or sealing device, eliminate the leakage of oil and muddy water, and clean the brake with kerosene or gasoline.

The above points of tractor maintenance are about the introduction of tractor braking system.

The operator should master these knowledge. As long as it is operated properly, there is no problem in prolonging its service life.

Pre: What are the common oil leakage accidents of tractors?
Next: Causes and solutions of vibration of full-automatic hydraulic brick press oil pump