Proper use of small tractors belt

60-65HP Tractor is a machine that was born ready to handle any chore on the farm, ranch. Proper use of small tractors belt:
1, The installation should be correct. When installed, the output shaft and the engine must be input shaft parallel to the transmission case, the diesel engine can be adjusted in position to solve the rack, and should the position of the belt pulley mounted vertically.
2, It should be appropriate tightness. To promptly adjust the tightness of the belt, the belt is too loose, it will cause slippage, not a good transmission of power; belt too tight, it will increase the engine power loss, and to wear the belt early. For rational use of belts, people tightness of the belt there is a specific request, even if the central belt is about four fingers pressed vertically 20 mm most appropriate.
3, It disassembly should be correct. When dismantling the belt, and some people only way to pry improper belt, but do not use tools properly, like with a blade or sharp edges to scratch or tool belt will draw the prints, so that the belt running at high speed, it will make the cracks gradually expanded and fracture.
4, The replacement should be reasonable. Choose a belt, I do not pay attention to the model or specification, replace the belt, you must replace a group, never any insertion of a belt or decrease.
5, To prevent oil pollution, sun exposure. Stained with oil, water belt, will not only affect their driving performance, increased sliding lower transmission efficiency, and a long time to make it easy to deteriorate and shorten life, it should be to prevent the use of a belt or stick coated with oil mud, Always remove dirt tape round slot, and should avoid sun exposure, aging tape to prevent deterioration.